Lunos e - One pair with one controller

$1,195.00

Add to Cart:

Lunos e is a decentralized ventilation system with a built-in regenerative heat recovery core.

The basic unit is a through wall fan, with a ceramic regenerative heat exchanger behind it. Operating and wired in pairs, these fans provide continuous ventilation without the need for duct-work and are installed directly in the exterior wall.
The fan's regenerative core is charged every 70 sec cycle, after which the fan reverses and the incoming air absorbs the stored heat on its way in and recovers this heat at 90.6% tested efficiency. The other fan balances this ventilation system by running in the opposing direction.



  • Ventilation rates: 10/15/20 CFM or 9/18/22CFM
  • Heat recovery efficiency: 90.6% (tested with DIN 308 / DIBt protocol)
  • Humidity recovery: 20-30%
  • Specific fan efficiency: 0.09 Wh/m3 (0.14 (W/cfm)
  • Ventilation system efficiency: 0.30 Wh/m3
  • Filter: G3 (MERV 5) or optional pollen F5 (MERV 9-10)
  • Sound levels: 17db - 19 dB - 26 dB
  • Includes one transformer (110V-12V) and controller. Maximum four fans (two pairs) can be wired to one controller.
  • Installation sleeve included - can be pre-installed in wall before insulating/during construction
  • Creating a very quiet heat recovery ventilation system without the need for ducts and balancing, with specific fan efficiency that is second to none.
    Lunos Section

    Dimensions:
  • HRV diameter: 150mm ~ 5.9
  • HRV length: 243mm ~ 9.6
  • Min. wall thickness: 300mm ~ 11.8
  • Core bore: 162mm ~ 6.37"

    For bathrooms it is recommended to have an intermittent high efficiency exhaust fan, which will decrease e efficiency slightly during the time it is in operation. Or if the bathroom is located an exterior wall a pair of E2's can be installed. The same principle can be applied to kitchens.

    Reference downloads
    Lunos e Installation instructions
    Lunos e Product Brochure
    Lunos e Cut Sheet
    Lunos e user manual

    Related blogposts
    The Lunos e Primer
    Sizing Lunos e through-wall ventilation units
    Tighter than expected: time to ventilate without compromise
    No Freezing Means No Defrost Mode for Lunos e High-Efficiency Ventilation
    Lunos e Testimonials
    Lunos e HRV data for input into PHPP ventilation sheet

    Related Products
    Interior seal  ROFLEX 150: Airtight, windtight, and waterproof sleeve that fits LUNOS e2 units.
    TESCON VANA 150 TESCON VANA: Use with ROFLEX 150 to create an exterior rated, waterproof connection.
    Exterior Use An alternative to ROFLEX 150: Use form fitting TESCON No.1 and work your way around the pipe with small pieces.


    475 cannot ship LUNOS products to Canada, if orders use a Canadian address the funds will be refunded minus a 3% credit card fee, apologies for the inconvenience

    Installation Video


    e2 installed in USA
    Lunos e installed in Ecocor project in Maine

  • Copyright © 2014 FourSevenFive